Submit a Work Order

The Rutt's Machine Shop, Inc. sign

Please fill out the form below to submit your work order.



Please check which services you require and someone will contact you immediately.


Quantity

Shop Operations

Yes

Engine - Recondition As Needed

Disassemble

Assemble

Block - Recondition As Needed

Please Supply Main Bolt Torque (Ft. Lbs.)

Clean & Magnaflux Block

Remove Cam Brgs. & Freeze & Oil Plugs

(Check / Line Hone / Bore) Main Bearing Housing Bores

(Spray Weld / Knurl) to tighten main caps

(Check / Resurface / Square Deck) Block

(Check / Bore & Hone) Cyls.

(Rigid / Flex) Hone Cyls. For New Rings

Bore & Install Repair Sleeve

Remachine Counterbores

(Remove / Measure & Install) Cylinder Sleeves

Pressure Test Block

Final Clean and Install Cam Brgs.

Final Clean and Install (Freeze / Oil) Plugs

Crank - Recondition As Needed

Clean & Mag. Crank

R&R Oil Plugs & Clean Oil Galleries

Check Shaft & Call

Polish Rod ( ) Main ( ) Journals

Regrind Rod Journals ( )

Regrind Main Journals ( )

Weld To Build-Up Rod Journal

Weld To Build-Up Main Journal

Weld To Build-Up Seal Surface

Weld To Build-Up Thrust

Stress Relieve in Oven

Blast Crank

Straighten Crank

Balance Crank Assembly

Clean Mag & Check Camshaft

Pistons - Clean & Blast

Remove, Clean & Install Pistons Onto Rods

Check Pistons

Rods - Recondition As Needed

Please Supply Rod Bolt Torque

Install New Rod Bolts

Clean & Magnaflux Rods

Check (Large End / Pin End)

Check Alignment & Adjust

Recondition Large End & Check Alignment

Rebush, Bore C to C, Fit & Check Alignment

Head(s) - Recondition As Needed

Basic Valve Job & Replace Freeze Plugs (Disassemble / Assemble Heads; Clean, Mag., & Remove Gaskets; Mic, Polish, Grind, Butt Valves; Machine Seats & Vacuum Test Are Included With Basic Valve Job)

Machine Seats to Min., Spec. (Int. / Ex.)

(Check / Average-Out) Valve Recession (Int. / Ex.)

(Check / Replace / Knurl) Guides & Fit As Needed

Bore & Install Guides & Fit As Needed

Bore & Install Valve Seats As Needed

Pull Seats & Install New As Needed

(Check / Resurface) Head(s) As Needed

Remove Broken (Bolts / Studs) & Heli-Coil

Resurface Rocker Arms

Replace Injector-Tubes

Pressure Test

Repair Cracks

Note: Send All Valves For Guide Fitting & Seat Work

Manifold(s) - (Clean / Resurface)

Flywheel - Resurface